International Case IH 544 656 Hydrostatic tractor — 44 pages — manual code: GSS-1405
TABLE OF CONTENTS:
Introduction
Do’s and Don’ts of Hydrostatic Tractor Servicing
Tools Required for Field and Shop Service Kit for Servicing 656 & 544 Series and 3514 & 3616 Hydrostatic Tractors
- Tools Required for Checking Charge Flow and Running Clean-Up Procedure
- Tools Required to Check all Pressures at the Same Time, and for Isolating Drive Control and Foot-N-Inch Valves
- Tools Required for Servicing Check Valves, Relief Valves and Servo Cylinders
- Miscellaneous Tools and Supplies
Basic Explanation of Each System Component and Possible Malfunctions
- High-Low Range Transmission
- S-R Lever and Effects of Poor S-R Lever Adjustment
- Center Section Shuttle Valve and Possible Malfunctions
- High Pressure Relief Valves
- Parts Which Can Cause High Pressure Valves to Open
- Drive Control Valve
- Foot-N-Inch Valve
- Servo Cylinders (How They Operate)
- Servo Cylinders (Possible Malfunctions)
- Pump Servo
- Motor Servo
Step-By-Step Checks During Trouble Shooting
- Step-By-Step Check Outline
- General
- Checking Statically
- Test Driving
- Checking Anti-Coast Valve
- Checking Reverse Deceleration
- Other Possible Malfunctions Which May Show Up During Driving Test
- Checking for Speed of Servo Response
- Further Checks After Test Driving
Checking Charge Flow on Tractors Equipped with Recirculating Filter Parts Accessory No. 530 976 R91
Clean-Up Procedure After Major Overhaul
Clean-Up Procedure for Tractors with Recirculating Filter
Installing Recirculating Filter
Checking Complaints of High Fuel Consumption or High Temperatures
Parts Which Can Be Removed Without Splitting the Tractor
