International C157 C175 C200 Engine Fuel System Service Manual PDF 14.99

International C157 C175 C200 — 88 pages — GSS1395J

Table of Content:

Section 1 –  Engine

Specifications

Service Procedure

• Valve Timing
• Valve Lash Adjusting Procedure
• Engine Removal
• Mounting the Engine to the Stand

Cylinder Head and Valves

• Valves and Valve Guides
• Valve Seats and Valve Seat Inserts
  • Removal
  • Repair
  • Installation
• Roto-Coils
  • Testing Rotators
• Cylinder Head Installation

Timing Gear Train and Front Cover

• Crankshaft Pulley Removal
• Front Cover
• Crankshaft Front Oil Seal

Camshaft

• Checking Camshaft Lobe Lilt (Camshaft in Engine)
• Preferred Method
• Checking Camshaft Lobe Wear (Camshaft Removed irom Engine)
• Alternate Method
• Inspection and Repair
• Installation
• Rear Bearing 
• Center Bearing
• Front Bearing

Crankshaft

• Rear Main Bearing Cap Removal
• Rear Main Bearing Cap Installation
• Crankshaft Rear Uil 6eal Kemoval
• Crankshaft Rear Oil Seal Installation
• Inspection and Repair
• Replacing Crankshaft Bearing Caps
• Crankshaft Re grinding
• Oil Pan Installation

Piston Fit in Bore

Crankcasc Cylinder Re-Boring Procedure

• When to Re-Bore
• Preparing the Block 
• Re-Boring
• Honing
• Cleaning
• Checking Clearance

Engine Balancer (C-175 and C-200 Engines)

• Description
• Balancer Operation as compared with Engines without the Balancer
• Removal
• Disassembly
• Inspection and Repair
• Crankshaft Balancer Drive Gear Replacement 
• Reassembly
• Installation

Engine Governor

• Principles of Operation
• Removal, Inspection and Repair
• Installation
• Adjustments

Lubrication System

• Oil Pump
• Oil Pump, Tachometcr Drive and Distributor Installation
• Oil Filter 
• Oil Pressure Regulator Valve

Water Pump (375 Windrower Only)

• Removal
• Disassembly
• Inspection ar.c Repair
• Reassembly
• Installation

Water Pump (Except 375 Windrower)

• Removal
• Disassembly
• Inspection and Repair
• Reassembly
• Installation

Thermostat Assembly

Break-In Procedure of Rebuilt Gasoline Engines

• Gas Engines
• Run-in When Dynamometer is Not Available
• Run-in When Dynamometer is Available

Section 2 – Fuel System

Carburetor Specifications

General Description

Carburetors

• Operation
  • Fuel Supply System
  • Idling System
  • Load System
  • Starting System
• Liquid Level Check
• Removal and Installation
• Inspection and Repair
  • Throttle Body and Fuel Bowl
  • Throttle Plate
  • Float Assembly
  • Fuel Needle Valve and Scat
  • Adjusting Screws and Scats
  • Venturi and Jets 
• Assembly and Adjustment